The document file describes how to set up a uadk log. Signed-off-by: Kai Ye <yekai13@huawei.com> --- docs/log.rst | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+) create mode 100644 docs/log.rst diff --git a/docs/log.rst b/docs/log.rst new file mode 100644 index 0000000..a8e7027 --- /dev/null +++ b/docs/log.rst @@ -0,0 +1,32 @@ + +The rsyslog.conf file is the main configuration file for the rsyslogd which logs system +messages on systems. The uadk library can set up the log level and log file by use the rsyslogd. +the uadk log can be printed in message or syslog file default. You can set your own uadk.log +file in rsyslog.conf. + +1. If selected the static compilation, the syslog will not be used, The information will be printed + on the serial port. +2. If not edited the rsyslog.conf, the log files will be printed in /var/log/messages. +3. If you don't want to use the rsyslogd, you can edit the Makefile.am. The information will be + printed on the serial port. +4. If you want to use the rsyslogd, you can see the following information. + +The uadk supports four setting commands, the log level parameters: + local5.err # display the error conditions + local5.info # display the warning and error conditions + local5.debug # display the debug,warning,error conditions + local5.* # print levels are not differentiated. + +The following steps will help you set up the syslog file: + +step 1: + Add the following information to the last line of /etc/rsyslog.conf: + local5.err /var/log/uadk.log + +step 2: + Restart the rsyslog deamon service. The cmd is: + service rsyslog restart + +After you run the tasks. You can see the uadk.log in /var/log/uadk/log. If you want to clear the +log file, you can use the following cmd: echo 0 > /var/log/uadk.log. + -- 2.30.0