When firewalld is inactive, return code of 'systemctl status firewalld' will be 3, and install-tiny has set -e, so this will cause this process exit. Signed-off-by: Hu XueJiao <huxuejiao1@huawei.com> --- sparrow/2-network/iptables | 22 +++++++++++++--------- 1 file changed, 13 insertions(+), 9 deletions(-) diff --git a/sparrow/2-network/iptables b/sparrow/2-network/iptables index 092c4ca..7183145 100755 --- a/sparrow/2-network/iptables +++ b/sparrow/2-network/iptables @@ -12,15 +12,19 @@ iptables -I FORWARD 1 -j ACCEPT iptables -t nat -A POSTROUTING -o "$PUB_IFACE" -s $BR0_SUBNET -j MASQUERADE iptables -t nat -A POSTROUTING -o $BR0_IFACE -d $BR0_SUBNET -j MASQUERADE -systemctl status firewalld | grep -q "running" && { +command -v firewall-cmd > /dev/null || { + echo "firewalld.service could not be found" + exit 0 +} - DOCKER0_IFACE=docker0 - DOCKER0_SUBNET=172.17.0.0/16 +systemctl start firewalld +[ "$(systemctl is-active firewalld)" == "active" ] || { + echo "start firewalld.service failed" + exit 0 +} - iptables -t nat -A POSTROUTING -o $PUB_IFACE -s $DOCKER0_SUBNET -j MASQUERADE - iptables -t nat -A POSTROUTING -o $DOCKER0_IFACE -d $DOCKER0_SUBNET -j MASQUERADE +DOCKER0_SUBNET=172.17.0.0/16 - firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=$DOCKER0_SUBNET accept" - firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=$BR0_SUBNET accept" - firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=0.0.0.0/32 accept" -} +firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=$DOCKER0_SUBNET accept" +firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=$BR0_SUBNET accept" +firewall-cmd --zone=public --add-rich-rule="rule family=ipv4 source address=0.0.0.0/32 accept" -- 2.23.0