From: Olga Kitaina <okitain@gmail.com> stable inclusion from stable-v5.10.137 commit 04c9d23ac352fb006fc013fca1b9690fe817108e category: bugfix bugzilla: https://gitee.com/openeuler/kernel/issues/I60PLB Reference: https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?id=... -------------------------------- [ Upstream commit e16eceea863b417fd328588b1be1a79de0bc937f ] According to the Arasan NAND controller spec, the flash clock rate for SDR must be <= 100 MHz, while for NV-DDR it must be the same as the rate of the CLK line for the mode. The driver previously always set 100 MHz for NV-DDR, which would result in incorrect behavior for NV-DDR modes 0-4. The appropriate clock rate can be calculated from the NV-DDR timing parameters as 1/tCK, or for rates measured in picoseconds, 10^12 / nand_nvddr_timings->tCK_min. Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller") CC: stable@vger.kernel.org # 5.8+ Signed-off-by: Olga Kitaina <okitain@gmail.com> Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xilinx.com> Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com> Link: https://lore.kernel.org/linux-mtd/20220628154824.12222-3-amit.kumar-mahapatr... Signed-off-by: Sasha Levin <sashal@kernel.org> Signed-off-by: Zheng Zengkai <zhengzengkai@huawei.com> Reviewed-by: Wei Li <liwei391@huawei.com> --- drivers/mtd/nand/raw/arasan-nand-controller.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-) diff --git a/drivers/mtd/nand/raw/arasan-nand-controller.c b/drivers/mtd/nand/raw/arasan-nand-controller.c index f926d658192b..50643c6f33f4 100644 --- a/drivers/mtd/nand/raw/arasan-nand-controller.c +++ b/drivers/mtd/nand/raw/arasan-nand-controller.c @@ -907,7 +907,13 @@ static int anfc_setup_interface(struct nand_chip *chip, int target, anand->timings = DIFACE_NVDDR | DIFACE_DDR_MODE(conf->timings.mode); - anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + if (nand_interface_is_sdr(conf)) { + anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + } else { + /* ONFI timings are defined in picoseconds */ + anand->clk = div_u64((u64)NSEC_PER_SEC * 1000, + conf->timings.nvddr.tCK_min); + } /* * Due to a hardware bug in the ZynqMP SoC, SDR timing modes 0-1 work -- 2.20.1