From: "Jason A. Donenfeld" <Jason@zx2c4.com> commit 67c9a7e1e3ac491b5df018803639addc36f154ba upstream. Because sunvnet is calling icmp from network device context, it should use the ndo helper so that the rate limiting applies correctly. While we're at it, doing the additional route lookup before calling icmp_ndo_send is superfluous, since this is the job of the icmp code in the first place. Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com> Cc: Shannon Nelson <shannon.nelson@oracle.com> Signed-off-by: David S. Miller <davem@davemloft.net> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> --- drivers/net/ethernet/sun/sunvnet_common.c | 23 ++++------------------- 1 file changed, 4 insertions(+), 19 deletions(-) diff --git a/drivers/net/ethernet/sun/sunvnet_common.c b/drivers/net/ethernet/sun/sunvnet_common.c index baa3088b475c7..59fc14b58c838 100644 --- a/drivers/net/ethernet/sun/sunvnet_common.c +++ b/drivers/net/ethernet/sun/sunvnet_common.c @@ -1353,27 +1353,12 @@ sunvnet_start_xmit_common(struct sk_buff *skb, struct net_device *dev, if (vio_version_after_eq(&port->vio, 1, 3)) localmtu -= VLAN_HLEN; - if (skb->protocol == htons(ETH_P_IP)) { - struct flowi4 fl4; - struct rtable *rt = NULL; - - memset(&fl4, 0, sizeof(fl4)); - fl4.flowi4_oif = dev->ifindex; - fl4.flowi4_tos = RT_TOS(ip_hdr(skb)->tos); - fl4.daddr = ip_hdr(skb)->daddr; - fl4.saddr = ip_hdr(skb)->saddr; - - rt = ip_route_output_key(dev_net(dev), &fl4); - if (!IS_ERR(rt)) { - skb_dst_set(skb, &rt->dst); - icmp_send(skb, ICMP_DEST_UNREACH, - ICMP_FRAG_NEEDED, - htonl(localmtu)); - } - } + if (skb->protocol == htons(ETH_P_IP)) + icmp_ndo_send(skb, ICMP_DEST_UNREACH, ICMP_FRAG_NEEDED, + htonl(localmtu)); #if IS_ENABLED(CONFIG_IPV6) else if (skb->protocol == htons(ETH_P_IPV6)) - icmpv6_send(skb, ICMPV6_PKT_TOOBIG, 0, localmtu); + icmpv6_ndo_send(skb, ICMPV6_PKT_TOOBIG, 0, localmtu); #endif goto out_dropped; } -- 2.25.1