hulk inclusion category: bugfix bugzilla: https://gitee.com/openeuler/kernel/issues/I8QLHB CVE: NA --------------------------- When I inject a PCIE Fatal error into a mellanox netdevice, 'dmesg' shows the device is recovered successfully, but 'lspci' didn't show the device. I checked the configuration space of the slot where the netdevice is inserted and found out the bit 'PCI_BRIDGE_CTL_BUS_RESET' is set. Later, I found out it is because this bit is saved in 'saved_config_space' of 'struct pci_dev' when 'pci_pm_runtime_suspend()' is called. And 'PCI_BRIDGE_CTL_BUS_RESET' is set every time we restore the configuration sapce. This patch avoid saving the bit 'PCI_BRIDGE_CTL_BUS_RESET' when we save the configuration space of a bridge. Signed-off-by: Xiongfeng Wang <wangxiongfeng2@huawei.com> Reviewed-by: Hanjun Guo <guohanjun@huawei.com> Signed-off-by: Jialin Zhang <zhangjialin11@huawei.com> --- drivers/pci/pci.c | 3 +++ 1 file changed, 3 insertions(+) diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c index a607f277ccf1..dab00ab19364 100644 --- a/drivers/pci/pci.c +++ b/drivers/pci/pci.c @@ -1692,6 +1692,9 @@ int pci_save_state(struct pci_dev *dev) pci_dbg(dev, "save config %#04x: %#010x\n", i * 4, dev->saved_config_space[i]); } + if (dev->hdr_type == PCI_HEADER_TYPE_BRIDGE) + dev->saved_config_space[PCI_BRIDGE_CONTROL / 4] &= + ~(PCI_BRIDGE_CTL_BUS_RESET << 16); dev->state_saved = true; i = pci_save_pcie_state(dev); -- 2.20.1