From: Ulf Hansson <ulf.hansson@linaro.org> [ Upstream commit d2f8bfa4bff5028bc40ed56b4497c32e05b0178f ] It has turned out that the sdhci-tegra controller requires the R1B response, for commands that has this response associated with them. So, converting from an R1B to an R1 response for a CMD6 for example, leads to problems with the HW busy detection support. Fix this by informing the mmc core about the requirement, via setting the host cap, MMC_CAP_NEED_RSP_BUSY. Reported-by: Bitan Biswas <bbiswas@nvidia.com> Reported-by: Peter Geis <pgwipeout@gmail.com> Suggested-by: Sowjanya Komatineni <skomatineni@nvidia.com> Cc: <stable@vger.kernel.org> Tested-by: Sowjanya Komatineni <skomatineni@nvidia.com> Tested-By: Peter Geis <pgwipeout@gmail.com> Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org> Signed-off-by: Sasha Levin <sashal@kernel.org> Signed-off-by: Yang Yingliang <yangyingliang@huawei.com> --- drivers/mmc/host/sdhci-tegra.c | 3 +++ 1 file changed, 3 insertions(+) diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c index 14d749a..27bdf6d 100644 --- a/drivers/mmc/host/sdhci-tegra.c +++ b/drivers/mmc/host/sdhci-tegra.c @@ -502,6 +502,9 @@ static int sdhci_tegra_probe(struct platform_device *pdev) if (tegra_host->soc_data->nvquirks & NVQUIRK_ENABLE_DDR50) host->mmc->caps |= MMC_CAP_1_8V_DDR; + /* R1B responses is required to properly manage HW busy detection. */ + host->mmc->caps |= MMC_CAP_NEED_RSP_BUSY; + tegra_host->power_gpio = devm_gpiod_get_optional(&pdev->dev, "power", GPIOD_OUT_HIGH); if (IS_ERR(tegra_host->power_gpio)) { -- 1.8.3