From: Michael Walle <michael@walle.cc> stable inclusion from stable-v5.10.150 commit e31c0e14cfad8a621832def190f63b72a701cfff category: bugfix bugzilla: https://gitee.com/openeuler/kernel/issues/I6D0XA Reference: https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?id=... -------------------------------- [ Upstream commit 2d528eda7c96ce5c70f895854ecd5684bd5d80b9 ] Both the Linkstation LS-CHLv2 and the LS-XHL have only one ethernet port. This has always been wrong, i.e. the board code used to set up both ports, but the driver will play nice and return -ENODEV if the assiciated PHY is not found. Nevertheless, it is wrong. Remove it. Fixes: 876e23333511 ("ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes") Signed-off-by: Michael Walle <michael@walle.cc> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com> Signed-off-by: Sasha Levin <sashal@kernel.org> Signed-off-by: Jialin Zhang <zhangjialin11@huawei.com> --- arch/arm/boot/dts/kirkwood-lsxl.dtsi | 11 ----------- 1 file changed, 11 deletions(-) diff --git a/arch/arm/boot/dts/kirkwood-lsxl.dtsi b/arch/arm/boot/dts/kirkwood-lsxl.dtsi index 321a40a98ed2..88b70ba1c8fe 100644 --- a/arch/arm/boot/dts/kirkwood-lsxl.dtsi +++ b/arch/arm/boot/dts/kirkwood-lsxl.dtsi @@ -218,22 +218,11 @@ hdd_power: regulator@2 { &mdio { status = "okay"; - ethphy0: ethernet-phy@0 { - reg = <0>; - }; - ethphy1: ethernet-phy@8 { reg = <8>; }; }; -ð0 { - status = "okay"; - ethernet0-port@0 { - phy-handle = <ðphy0>; - }; -}; - ð1 { status = "okay"; ethernet1-port@0 { -- 2.25.1