From: Alex Williamson <alex.williamson@redhat.com> mainline inclusion from mainline-v5.8-rc3 commit ebfa440ce38b7e2e04c3124aa89c8a9f4094cf21 category: bugfix bugzilla: NA CVE: CVE-2020-12888 --------------------------- SR-IOV VFs do not implement the memory enable bit of the command register, therefore this bit is not set in config space after pci_enable_device(). This leads to an unintended difference between PF and VF in hand-off state to the user. We can correct this by setting the initial value of the memory enable bit in our virtualized config space. There's really no need however to ever fault a user on a VF though as this would only indicate an error in the user's management of the enable bit, versus a PF where the same access could trigger hardware faults. Fixes: abafbc551fdd ("vfio-pci: Invalidate mmaps and block MMIO access on disabled memory") Signed-off-by: Alex Williamson <alex.williamson@redhat.com> Signed-off-by: Yang Yingliang <yangyingliang@huawei.com> Reviewed-by: Jason Yan <yanaijie@huawei.com> Signed-off-by: Yang Yingliang <yangyingliang@huawei.com> --- drivers/vfio/pci/vfio_pci_config.c | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-) diff --git a/drivers/vfio/pci/vfio_pci_config.c b/drivers/vfio/pci/vfio_pci_config.c index 4fe71fbce194..a1a26465d224 100644 --- a/drivers/vfio/pci/vfio_pci_config.c +++ b/drivers/vfio/pci/vfio_pci_config.c @@ -401,9 +401,15 @@ static inline void p_setd(struct perm_bits *p, int off, u32 virt, u32 write) /* Caller should hold memory_lock semaphore */ bool __vfio_pci_memory_enabled(struct vfio_pci_device *vdev) { + struct pci_dev *pdev = vdev->pdev; u16 cmd = le16_to_cpu(*(__le16 *)&vdev->vconfig[PCI_COMMAND]); - return cmd & PCI_COMMAND_MEMORY; + /* + * SR-IOV VF memory enable is handled by the MSE bit in the + * PF SR-IOV capability, there's therefore no need to trigger + * faults based on the virtual value. + */ + return pdev->is_virtfn || (cmd & PCI_COMMAND_MEMORY); } /* @@ -1732,6 +1738,15 @@ int vfio_config_init(struct vfio_pci_device *vdev) vconfig[PCI_INTERRUPT_PIN]); vconfig[PCI_INTERRUPT_PIN] = 0; /* Gratuitous for good VFs */ + + /* + * VFs do no implement the memory enable bit of the COMMAND + * register therefore we'll not have it set in our initial + * copy of config space after pci_enable_device(). For + * consistency with PFs, set the virtual enable bit here. + */ + *(__le16 *)&vconfig[PCI_COMMAND] |= + cpu_to_le16(PCI_COMMAND_MEMORY); } if (!IS_ENABLED(CONFIG_VFIO_PCI_INTX) || vdev->nointx) -- 2.25.1