[PATCH OLK-5.10] arm64/mm: Enable batched TLB flush in unmap_hotplug_range()
From: Anshuman Khandual <anshuman.khandual@arm.com> stable inclusion from stable-v6.12.86 commit 7260b0ec7a84023412f8c26a456ee9a23e29bdb6 category: bugfix bugzilla: https://atomgit.com/openeuler/kernel/issues/9219 Reference: https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?id=... -------------------------------- commit 48478b9f791376b4b89018d7afdfd06865498f65 upstream. During a memory hot remove operation, both linear and vmemmap mappings for the memory range being removed, get unmapped via unmap_hotplug_range() but mapped pages get freed only for vmemmap mapping. This is just a sequential operation where each table entry gets cleared, followed by a leaf specific TLB flush, and then followed by memory free operation when applicable. This approach was simple and uniform both for vmemmap and linear mappings. But linear mapping might contain CONT marked block memory where it becomes necessary to first clear out all entire in the range before a TLB flush. This is as per the architecture requirement. Hence batch all TLB flushes during the table tear down walk and finally do it in unmap_hotplug_range(). Prior to this fix, it was hypothetically possible for a speculative access to a higher address in the contiguous block to fill the TLB with shattered entries for the entire contiguous range after a lower address had already been cleared and invalidated. Due to the table entries being shattered, the subsequent TLB invalidation for the higher address would not then clear the TLB entries for the lower address, meaning stale TLB entries could persist. Besides it also helps in improving the performance via TLBI range operation along with reduced synchronization instructions. The time spent executing unmap_hotplug_range() improved 97% measured over a 2GB memory hot removal in KVM guest. This scheme is not applicable during vmemmap mapping tear down where memory needs to be freed and hence a TLB flush is required after clearing out page table entry. Cc: Will Deacon <will@kernel.org> Cc: linux-arm-kernel@lists.infradead.org Cc: linux-kernel@vger.kernel.org Closes: https://lore.kernel.org/all/aWZYXhrT6D2M-7-N@willie-the-truck/ Fixes: bbd6ec605c0f ("arm64/mm: Enable memory hot remove") Cc: stable@vger.kernel.org Reviewed-by: David Hildenbrand (Arm) <david@kernel.org> Reviewed-by: Ryan Roberts <ryan.roberts@arm.com> Signed-off-by: Ryan Roberts <ryan.roberts@arm.com> Signed-off-by: Anshuman Khandual <anshuman.khandual@arm.com> Signed-off-by: Catalin Marinas <catalin.marinas@arm.com> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Conflicts: arch/arm64/mm/mmu.c [Conflicts due to commit 5a00bfd6a52c ("arm64/mm: new ptep layer to manage contig bit") update pte_clear to __pte_clear, that is fine.] Signed-off-by: Wupeng Ma <mawupeng1@huawei.com> --- arch/arm64/mm/mmu.c | 36 ++++++++++++++++++++---------------- 1 file changed, 20 insertions(+), 16 deletions(-) diff --git a/arch/arm64/mm/mmu.c b/arch/arm64/mm/mmu.c index adaca1fd5a277..a1f7080643a86 100644 --- a/arch/arm64/mm/mmu.c +++ b/arch/arm64/mm/mmu.c @@ -874,10 +874,14 @@ static void unmap_hotplug_pte_range(pmd_t *pmdp, unsigned long addr, WARN_ON(!pte_present(pte)); pte_clear(&init_mm, addr, ptep); - flush_tlb_kernel_range(addr, addr + PAGE_SIZE); - if (free_mapped) + if (free_mapped) { + /* CONT blocks are not supported in the vmemmap */ + WARN_ON(pte_cont(pte)); + flush_tlb_kernel_range(addr, addr + PAGE_SIZE); free_hotplug_page_range(pte_page(pte), PAGE_SIZE, altmap); + } + /* unmap_hotplug_range() flushes TLB for !free_mapped */ } while (addr += PAGE_SIZE, addr < end); } @@ -898,15 +902,14 @@ static void unmap_hotplug_pmd_range(pud_t *pudp, unsigned long addr, WARN_ON(!pmd_present(pmd)); if (pmd_sect(pmd)) { pmd_clear(pmdp); - - /* - * One TLBI should be sufficient here as the PMD_SIZE - * range is mapped with a single block entry. - */ - flush_tlb_kernel_range(addr, addr + PAGE_SIZE); - if (free_mapped) + if (free_mapped) { + /* CONT blocks are not supported in the vmemmap */ + WARN_ON(pmd_cont(pmd)); + flush_tlb_kernel_range(addr, addr + PMD_SIZE); free_hotplug_page_range(pmd_page(pmd), PMD_SIZE, altmap); + } + /* unmap_hotplug_range() flushes TLB for !free_mapped */ continue; } WARN_ON(!pmd_table(pmd)); @@ -931,15 +934,12 @@ static void unmap_hotplug_pud_range(p4d_t *p4dp, unsigned long addr, WARN_ON(!pud_present(pud)); if (pud_sect(pud)) { pud_clear(pudp); - - /* - * One TLBI should be sufficient here as the PUD_SIZE - * range is mapped with a single block entry. - */ - flush_tlb_kernel_range(addr, addr + PAGE_SIZE); - if (free_mapped) + if (free_mapped) { + flush_tlb_kernel_range(addr, addr + PUD_SIZE); free_hotplug_page_range(pud_page(pud), PUD_SIZE, altmap); + } + /* unmap_hotplug_range() flushes TLB for !free_mapped */ continue; } WARN_ON(!pud_table(pud)); @@ -969,6 +969,7 @@ static void unmap_hotplug_p4d_range(pgd_t *pgdp, unsigned long addr, static void unmap_hotplug_range(unsigned long addr, unsigned long end, bool free_mapped, struct vmem_altmap *altmap) { + unsigned long start = addr; unsigned long next; pgd_t *pgdp, pgd; @@ -990,6 +991,9 @@ static void unmap_hotplug_range(unsigned long addr, unsigned long end, WARN_ON(!pgd_present(pgd)); unmap_hotplug_p4d_range(pgdp, addr, next, free_mapped, altmap); } while (addr = next, addr < end); + + if (!free_mapped) + flush_tlb_kernel_range(start, end); } static void free_empty_pte_table(pmd_t *pmdp, unsigned long addr, -- 2.43.0
反馈: 您发送到kernel@openeuler.org的补丁/补丁集,转换为PR失败! 邮件列表地址:https://mailweb.openeuler.org/archives/list/kernel@openeuler.org/message/MYR... 失败原因:调用atomgit api创建PR失败, 失败原因如下: Another open merge request already exists for this source branch: !22792 建议解决方法:请稍等,机器人会在下一次任务重新执行 FeedBack: The patch(es) which you have sent to kernel@openeuler.org has been converted to PR failed! Mailing list address: https://mailweb.openeuler.org/archives/list/kernel@openeuler.org/message/MYR... Failed Reason: create PR failed when call atomgit's api, failed reason is as follows: Another open merge request already exists for this source branch: !22792 Suggest Solution: please wait, the bot will retry in the next interval
反馈: 您发送到kernel@openeuler.org的补丁/补丁集,已成功转换为PR! PR链接地址: https://atomgit.com/openeuler/kernel/merge_requests/22793 邮件列表地址:https://mailweb.openeuler.org/archives/list/kernel@openeuler.org/message/MYR... FeedBack: The patch(es) which you have sent to kernel@openeuler.org mailing list has been converted to a pull request successfully! Pull request link: https://atomgit.com/openeuler/kernel/merge_requests/22793 Mailing list address: https://mailweb.openeuler.org/archives/list/kernel@openeuler.org/message/MYR...
participants (2)
-
patchwork bot -
Wupeng Ma