From: Eric Biggers <ebiggers@kernel.org> mainline inclusion from mainline-v6.16-rc7 commit b41c1d8d07906786c60893980d52688f31d114a6 category: bugfix bugzilla: https://gitee.com/src-openeuler/kernel/issues/ICQ8LW Reference: https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/?i... -------------------------------- Make fscrypt no longer use Crypto API drivers for non-inline crypto engines, even when the Crypto API prioritizes them over CPU-based code (which unfortunately it often does). These drivers tend to be really problematic, especially for fscrypt's workload. This commit has no effect on inline crypto engines, which are different and do work well. Specifically, exclude drivers that have CRYPTO_ALG_KERN_DRIVER_ONLY or CRYPTO_ALG_ALLOCATES_MEMORY set. (Later, CRYPTO_ALG_ASYNC should be excluded too. That's omitted for now to keep this commit backportable, since until recently some CPU-based code had CRYPTO_ALG_ASYNC set.) There are two major issues with these drivers: bugs and performance. First, these drivers tend to be buggy. They're fundamentally much more error-prone and harder to test than the CPU-based code. They often don't get tested before kernel releases, and even if they do, the crypto self-tests don't properly test these drivers. Released drivers have en/decrypted or hashed data incorrectly. These bugs cause issues for fscrypt users who often didn't even want to use these drivers, e.g.: - https://github.com/google/fscryptctl/issues/32 - https://github.com/google/fscryptctl/issues/9 - https://lore.kernel.org/r/PH0PR02MB731916ECDB6C613665863B6CFFAA2@PH0PR02MB73... These drivers have also similarly caused issues for dm-crypt users, including data corruption and deadlocks. Since Linux v5.10, dm-crypt has disabled most of them by excluding CRYPTO_ALG_ALLOCATES_MEMORY. Second, these drivers tend to be *much* slower than the CPU-based code. This may seem counterintuitive, but benchmarks clearly show it. There's a *lot* of overhead associated with going to a hardware driver, off the CPU, and back again. To prove this, I gathered as many systems with this type of crypto engine as I could, and I measured synchronous encryption of 4096-byte messages (which matches fscrypt's workload): Intel Emerald Rapids server: AES-256-XTS: xts-aes-vaes-avx512 16171 MB/s [CPU-based, Vector AES] qat_aes_xts 289 MB/s [Offload, Intel QuickAssist] Qualcomm SM8650 HDK: AES-256-XTS: xts-aes-ce 4301 MB/s [CPU-based, ARMv8 Crypto Extensions] xts-aes-qce 73 MB/s [Offload, Qualcomm Crypto Engine] i.MX 8M Nano LPDDR4 EVK: AES-256-XTS: xts-aes-ce 647 MB/s [CPU-based, ARMv8 Crypto Extensions] xts(ecb-aes-caam) 20 MB/s [Offload, CAAM] AES-128-CBC-ESSIV: essiv(cbc-aes-caam,sha256-lib) 23 MB/s [Offload, CAAM] STM32MP157F-DK2: AES-256-XTS: xts-aes-neonbs 13.2 MB/s [CPU-based, ARM NEON] xts(stm32-ecb-aes) 3.1 MB/s [Offload, STM32 crypto engine] AES-128-CBC-ESSIV: essiv(cbc-aes-neonbs,sha256-lib) 14.7 MB/s [CPU-based, ARM NEON] essiv(stm32-cbc-aes,sha256-lib) 3.2 MB/s [Offload, STM32 crypto engine] Adiantum: adiantum(xchacha12-arm,aes-arm,nhpoly1305-neon) 52.8 MB/s [CPU-based, ARM scalar + NEON] So, there was no case in which the crypto engine was even *close* to being faster. On the first three, which have AES instructions in the CPU, the CPU was 30 to 55 times faster (!). Even on STM32MP157F-DK2 which has a Cortex-A7 CPU that doesn't have AES instructions, AES was over 4 times faster on the CPU. And Adiantum encryption, which is what actually should be used on CPUs like that, was over 17 times faster. Other justifications that have been given for these non-inline crypto engines (almost always coming from the hardware vendors, not actual users) don't seem very plausible either: - The crypto engine throughput could be improved by processing multiple requests concurrently. Currently irrelevant to fscrypt, since it doesn't do that. This would also be complex, and unhelpful in many cases. 2 of the 4 engines I tested even had only one queue. - Some of the engines, e.g. STM32, support hardware keys. Also currently irrelevant to fscrypt, since it doesn't support these. Interestingly, the STM32 driver itself doesn't support this either. - Free up CPU for other tasks and/or reduce energy usage. Not very plausible considering the "short" message length, driver overhead, and scheduling overhead. There's just very little time for the CPU to do something else like run another task or enter low-power state, before the message finishes and it's time to process the next one. - Some of these engines resist power analysis and electromagnetic attacks, while the CPU-based crypto generally does not. In theory, this sounds great. In practice, if this benefit requires the use of an off-CPU offload that massively regresses performance and has a low-quality, buggy driver, the price for this hardening (which is not relevant to most fscrypt users, and tends to be incomplete) is just too high. Inline crypto engines are much more promising here, as are on-CPU solutions like RISC-V High Assurance Cryptography. Fixes: b30ab0e03407 ("ext4 crypto: add ext4 encryption facilities") Cc: stable@vger.kernel.org Acked-by: Ard Biesheuvel <ardb@kernel.org> Link: https://lore.kernel.org/r/20250704070322.20692-1-ebiggers@kernel.org Signed-off-by: Eric Biggers <ebiggers@kernel.org> Conflicts: Documentation/filesystems/fscrypt.rst fs/crypto/fscrypt_private.h fs/crypto/hkdf.c [Context changed] Signed-off-by: Yongjian Sun <sunyongjian1@huawei.com> --- Documentation/filesystems/fscrypt.rst | 37 +++++++++++---------------- fs/crypto/fscrypt_private.h | 17 ++++++++++++ fs/crypto/hkdf.c | 2 +- fs/crypto/keysetup.c | 3 ++- fs/crypto/keysetup_v1.c | 3 ++- 5 files changed, 37 insertions(+), 25 deletions(-) diff --git a/Documentation/filesystems/fscrypt.rst b/Documentation/filesystems/fscrypt.rst index a624e92f2687..8e2f550b0169 100644 --- a/Documentation/filesystems/fscrypt.rst +++ b/Documentation/filesystems/fscrypt.rst @@ -141,9 +141,8 @@ However, these ioctls have some limitations: CONFIG_PAGE_POISONING=y in your kernel config and add page_poison=1 to your kernel command line. However, this has a performance cost. -- Secret keys might still exist in CPU registers, in crypto - accelerator hardware (if used by the crypto API to implement any of - the algorithms), or in other places not explicitly considered here. +- Secret keys might still exist in CPU registers or in other places + not explicitly considered here. Limitations of v1 policies ~~~~~~~~~~~~~~~~~~~~~~~~~~ @@ -375,9 +374,12 @@ the work is done by XChaCha12, which is much faster than AES when AES acceleration is unavailable. For more information about Adiantum, see `the Adiantum paper <https://eprint.iacr.org/2018/720.pdf>`_. -The (AES-128-CBC-ESSIV, AES-128-CTS-CBC) pair exists only to support -systems whose only form of AES acceleration is an off-CPU crypto -accelerator such as CAAM or CESA that does not support XTS. +The (AES-128-CBC-ESSIV, AES-128-CBC-CTS) pair was added to try to +provide a more efficient option for systems that lack AES instructions +in the CPU but do have a non-inline crypto engine such as CAAM or CESA +that supports AES-CBC (and not AES-XTS). This is deprecated. It has +been shown that just doing AES on the CPU is actually faster. +Moreover, Adiantum is faster still and is recommended on such systems. The remaining mode pairs are the "national pride ciphers": @@ -1231,22 +1233,13 @@ this by validating all top-level encryption policies prior to access. Inline encryption support ========================= -By default, fscrypt uses the kernel crypto API for all cryptographic -operations (other than HKDF, which fscrypt partially implements -itself). The kernel crypto API supports hardware crypto accelerators, -but only ones that work in the traditional way where all inputs and -outputs (e.g. plaintexts and ciphertexts) are in memory. fscrypt can -take advantage of such hardware, but the traditional acceleration -model isn't particularly efficient and fscrypt hasn't been optimized -for it. - -Instead, many newer systems (especially mobile SoCs) have *inline -encryption hardware* that can encrypt/decrypt data while it is on its -way to/from the storage device. Linux supports inline encryption -through a set of extensions to the block layer called *blk-crypto*. -blk-crypto allows filesystems to attach encryption contexts to bios -(I/O requests) to specify how the data will be encrypted or decrypted -in-line. For more information about blk-crypto, see +Many newer systems (especially mobile SoCs) have *inline encryption +hardware* that can encrypt/decrypt data while it is on its way to/from +the storage device. Linux supports inline encryption through a set of +extensions to the block layer called *blk-crypto*. blk-crypto allows +filesystems to attach encryption contexts to bios (I/O requests) to +specify how the data will be encrypted or decrypted in-line. For more +information about blk-crypto, see :ref:`Documentation/block/inline-encryption.rst <inline_encryption>`. On supported filesystems (currently ext4 and f2fs), fscrypt can use diff --git a/fs/crypto/fscrypt_private.h b/fs/crypto/fscrypt_private.h index 2d63da48635a..b7438536bc8d 100644 --- a/fs/crypto/fscrypt_private.h +++ b/fs/crypto/fscrypt_private.h @@ -27,6 +27,23 @@ */ #define FSCRYPT_MIN_KEY_SIZE 16 +/* + * This mask is passed as the third argument to the crypto_alloc_*() functions + * to prevent fscrypt from using the Crypto API drivers for non-inline crypto + * engines. Those drivers have been problematic for fscrypt. fscrypt users + * have reported hangs and even incorrect en/decryption with these drivers. + * Since going to the driver, off CPU, and back again is really slow, such + * drivers can be over 50 times slower than the CPU-based code for fscrypt's + * workload. Even on platforms that lack AES instructions on the CPU, using the + * offloads has been shown to be slower, even staying with AES. (Of course, + * Adiantum is faster still, and is the recommended option on such platforms...) + * + * Note that fscrypt also supports inline crypto engines. Those don't use the + * Crypto API and work much better than the old-style (non-inline) engines. + */ +#define FSCRYPT_CRYPTOAPI_MASK \ + (CRYPTO_ALG_ALLOCATES_MEMORY | CRYPTO_ALG_KERN_DRIVER_ONLY) + #define FSCRYPT_CONTEXT_V1 1 #define FSCRYPT_CONTEXT_V2 2 diff --git a/fs/crypto/hkdf.c b/fs/crypto/hkdf.c index 5a384dad2c72..b7f5e7884e03 100644 --- a/fs/crypto/hkdf.c +++ b/fs/crypto/hkdf.c @@ -72,7 +72,7 @@ int fscrypt_init_hkdf(struct fscrypt_hkdf *hkdf, const u8 *master_key, u8 prk[HKDF_HASHLEN]; int err; - hmac_tfm = crypto_alloc_shash(HKDF_HMAC_ALG, 0, 0); + hmac_tfm = crypto_alloc_shash(HKDF_HMAC_ALG, 0, FSCRYPT_CRYPTOAPI_MASK); if (IS_ERR(hmac_tfm)) { fscrypt_err(NULL, "Error allocating " HKDF_HMAC_ALG ": %ld", PTR_ERR(hmac_tfm)); diff --git a/fs/crypto/keysetup.c b/fs/crypto/keysetup.c index 361f41ef46c7..2348fc2a47f8 100644 --- a/fs/crypto/keysetup.c +++ b/fs/crypto/keysetup.c @@ -103,7 +103,8 @@ fscrypt_allocate_skcipher(struct fscrypt_mode *mode, const u8 *raw_key, struct crypto_skcipher *tfm; int err; - tfm = crypto_alloc_skcipher(mode->cipher_str, 0, 0); + tfm = crypto_alloc_skcipher(mode->cipher_str, 0, + FSCRYPT_CRYPTOAPI_MASK); if (IS_ERR(tfm)) { if (PTR_ERR(tfm) == -ENOENT) { fscrypt_warn(inode, diff --git a/fs/crypto/keysetup_v1.c b/fs/crypto/keysetup_v1.c index 75dabd9b27f9..159dd0288349 100644 --- a/fs/crypto/keysetup_v1.c +++ b/fs/crypto/keysetup_v1.c @@ -52,7 +52,8 @@ static int derive_key_aes(const u8 *master_key, struct skcipher_request *req = NULL; DECLARE_CRYPTO_WAIT(wait); struct scatterlist src_sg, dst_sg; - struct crypto_skcipher *tfm = crypto_alloc_skcipher("ecb(aes)", 0, 0); + struct crypto_skcipher *tfm = + crypto_alloc_skcipher("ecb(aes)", 0, FSCRYPT_CRYPTOAPI_MASK); if (IS_ERR(tfm)) { res = PTR_ERR(tfm); -- 2.39.2