Some Zhaoxin xHCI controllers follow usb3.1 spec, but only support gen1 speed 5G. While in Linux kernel, if xHCI suspport usb3.1,root hub speed will show on 10G. To fix this issue, read usb speed ID supported by xHCI to determine root hub speed. Signed-off-by: LeoLiu-oc <LeoLiu-oc@zhaoxin.com> ---  drivers/usb/host/xhci.c | 19 +++++++++++++++++++  1 file changed, 19 insertions(+) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index a834f3927bee..e9d67ee299d9 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -5186,6 +5186,7 @@ int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks)       */      struct device        *dev = hcd->self.sysdev;      unsigned int        minor_rev; +    u8            i, j;      int            retval;      /* Accept arbitrarily long scatter-gather lists */ @@ -5240,6 +5241,24 @@ int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks)              hcd->self.root_hub->speed = USB_SPEED_SUPER_PLUS;              break;          } + +        /* usb3.1 has gen1 and gen2, Some zx's xHCI controller that follow usb3.1 spec +         * but only support gen1 +         */ +        if (xhci->quirks & XHCI_ZHAOXIN_HOST) { +            minor_rev = 0; +            for (j = 0; j < xhci->num_port_caps; j++) { +                for (i = 0; i < xhci->port_caps[j].psi_count; i++) { +                    if (XHCI_EXT_PORT_PSIV(xhci->port_caps[j].psi[i]) >= 5) +                        minor_rev = 1; +                } +                if (minor_rev != 1) { +                    hcd->speed = HCD_USB3; +                    hcd->self.root_hub->speed = USB_SPEED_SUPER; +                } +            } +        } +          xhci_info(xhci, "Host supports USB 3.%x %sSuperSpeed\n",                minor_rev,                minor_rev ? "Enhanced " : ""); -- 2.20.1