driver inclusion category: bugfix bugzilla: https://gitee.com/openeuler/kernel/issues/I86GWG CVE: NA ----------------------------------------------------------------------- We find that some disks use D2H frame instead of SDB frame to return NCQ error. Currently, only the I/O corresponding to the D2H frame is processed in this scenario, which does not meet the processing requirements of the NCQ error scenario. So we set dev_status to HISI_SAS_DEV_NCQ_ERR and abort all I/Os of the disk in this scenario. Signed-off-by: Xingui Yang <yangxingui@huawei.com> Reviewed-by: Xiang Chen <chenxiang66@hisilicon.com> --- drivers/scsi/hisi_sas/hisi_sas_v3_hw.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c index f79060fca..79010d02a 100644 --- a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c +++ b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c @@ -2341,7 +2341,15 @@ slot_err_v3_hw(struct hisi_hba *hisi_hba, struct sas_task *task, case SAS_PROTOCOL_SATA | SAS_PROTOCOL_STP: if ((dw0 & CMPLT_HDR_RSPNS_XFRD_MSK) && (sipc_rx_err_type & RX_FIS_STATUS_ERR_MSK)) { - ts->stat = SAS_PROTO_RESPONSE; + if (task->ata_task.use_ncq) { + struct domain_device *device = task->dev; + struct hisi_sas_device *sas_dev = + device->lldd_dev; + sas_dev->dev_status = HISI_SAS_DEV_NCQ_ERR; + slot->abort = 1; + } else { + ts->stat = SAS_PROTO_RESPONSE; + } } else if ((dw3 & CMPLT_HDR_IO_IN_TARGET_MSK) || (dw3 & SATA_DISK_IN_ERROR_STATUS)) { ts->stat = SAS_PHY_DOWN; -- 2.17.1