From: Marek Vasut marex@denx.de
[ Upstream commit 0da1ccbbefb662915228bc17e1c7d4ad28b3ddab ]
The phy_reset_after_clk_enable() does a PHY reset, which means the PHY loses its register settings. The fec_enet_mii_probe() starts the PHY and does the necessary calls to configure the PHY via PHY framework, and loads the correct register settings into the PHY. Therefore, fec_enet_mii_probe() should be called only after the PHY has been reset, not before as it is now.
Fixes: 1b0a83ac04e3 ("net: fec: add phy_reset_after_clk_enable() support") Reviewed-by: Andrew Lunn andrew@lunn.ch Tested-by: Richard Leitner richard.leitner@skidata.com Signed-off-by: Marek Vasut marex@denx.de Cc: Christoph Niedermaier cniedermaier@dh-electronics.com Cc: David S. Miller davem@davemloft.net Cc: NXP Linux Team linux-imx@nxp.com Cc: Shawn Guo shawnguo@kernel.org Signed-off-by: Jakub Kicinski kuba@kernel.org Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/net/ethernet/freescale/fec_main.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/freescale/fec_main.c b/drivers/net/ethernet/freescale/fec_main.c index a81f5ced39f1..7d1a669416f2 100644 --- a/drivers/net/ethernet/freescale/fec_main.c +++ b/drivers/net/ethernet/freescale/fec_main.c @@ -2950,17 +2950,17 @@ fec_enet_open(struct net_device *ndev) /* Init MAC prior to mii bus probe */ fec_restart(ndev);
- /* Probe and connect to PHY when open the interface */ - ret = fec_enet_mii_probe(ndev); - if (ret) - goto err_enet_mii_probe; - /* Call phy_reset_after_clk_enable() again if it failed during * phy_reset_after_clk_enable() before because the PHY wasn't probed. */ if (reset_again) fec_enet_phy_reset_after_clk_enable(ndev);
+ /* Probe and connect to PHY when open the interface */ + ret = fec_enet_mii_probe(ndev); + if (ret) + goto err_enet_mii_probe; + if (fep->quirks & FEC_QUIRK_ERR006687) imx6q_cpuidle_fec_irqs_used();