From: Hans de Goede hdegoede@redhat.com
[ Upstream commit a23680594da7a9e2696dbcf4f023e9273e2fa40b ]
Suspending Goodix touchscreens requires changing the interrupt pin to output before sending them a power-down command. Followed by wiggling the interrupt pin to wake the device up, after which it is put back in input mode.
On Bay Trail devices with a Goodix touchscreen direct-irq mode is used in combination with listing the pin as a normal GpioIo resource.
This works fine, until the goodix driver gets rmmod-ed and then insmod-ed again. In this case byt_gpio_disable_free() calls byt_gpio_clear_triggering() which clears the IRQ flags and after that the (direct) IRQ no longer triggers.
This commit fixes this by adding a check for the BYT_DIRECT_IRQ_EN flag to byt_gpio_clear_triggering().
Note that byt_gpio_clear_triggering() only gets called from byt_gpio_disable_free() for direct-irq enabled pins, as these are excluded from the irq_valid mask by byt_init_irq_valid_mask().
Signed-off-by: Hans de Goede hdegoede@redhat.com Acked-by: Mika Westerberg mika.westerberg@linux.intel.com Reviewed-by: Linus Walleij linus.walleij@linaro.org Signed-off-by: Andy Shevchenko andriy.shevchenko@linux.intel.com Signed-off-by: Sasha Levin sashal@kernel.org Signed-off-by: Yang Yingliang yangyingliang@huawei.com --- drivers/pinctrl/intel/pinctrl-baytrail.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/pinctrl/intel/pinctrl-baytrail.c b/drivers/pinctrl/intel/pinctrl-baytrail.c index 021e28f..a760d8b 100644 --- a/drivers/pinctrl/intel/pinctrl-baytrail.c +++ b/drivers/pinctrl/intel/pinctrl-baytrail.c @@ -950,7 +950,13 @@ static void byt_gpio_clear_triggering(struct byt_gpio *vg, unsigned int offset)
raw_spin_lock_irqsave(&byt_lock, flags); value = readl(reg); - value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL); + + /* Do not clear direct-irq enabled IRQs (from gpio_disable_free) */ + if (value & BYT_DIRECT_IRQ_EN) + /* nothing to do */ ; + else + value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL); + writel(value, reg); raw_spin_unlock_irqrestore(&byt_lock, flags); }