From: Jon Hunter jonathanh@nvidia.com
[ Upstream commit bba25915b172c72f6fa635f091624d799e3c9cae ]
The 'phy-mode' property is currently defined as 'rgmii' for Jetson Xavier. This indicates that the RGMII RX and TX delays are set by the MAC and the internal delays set by the PHY are not used.
If the Marvell PHY driver is enabled, such that it is used and not the generic PHY, ethernet failures are seen (DHCP is failing to obtain an IP address) and this is caused because the Marvell PHY driver is disabling the internal RX and TX delays. For Jetson Xavier the internal PHY RX and TX delay should be used and so fix this by setting the 'phy-mode' to 'rgmii-id' and not 'rgmii'.
Fixes: f89b58ce71a9 ("arm64: tegra: Add ethernet controller on Tegra194") Signed-off-by: Jon Hunter jonathanh@nvidia.com Signed-off-by: Thierry Reding treding@nvidia.com Signed-off-by: Sasha Levin sashal@kernel.org Signed-off-by: Yang Yingliang yangyingliang@huawei.com --- arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi index 57d3f00464ce..7352954e12be 100644 --- a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi +++ b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi @@ -32,7 +32,7 @@
phy-reset-gpios = <&gpio TEGRA194_MAIN_GPIO(G, 5) GPIO_ACTIVE_LOW>; phy-handle = <&phy>; - phy-mode = "rgmii"; + phy-mode = "rgmii-id";
mdio { #address-cells = <1>;