From: Juxin Gao gaojuxin@loongson.cn

LoongArch inclusion category: feature bugzilla: https://gitee.com/openeuler/kernel/issues/I9R7M9

------------------------------------------

When we test wangxun network card ,we get failed. The reason is wangxun driver request a large minvec (33 or bigger), and it failed on LoongArch machine. Usually, it is not necessary to set the minimum number of MSI-X interrupts used to such a large number, so we limit it

Signed-off-by: Juxin Gao gaojuxin@loongson.cn Signed-off-by: Hongchen Zhang zhanghongchen@loongson.cn --- drivers/pci/msi/msi.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/pci/msi/msi.c b/drivers/pci/msi/msi.c index cde8c4e264b7..7078200be11f 100644 --- a/drivers/pci/msi/msi.c +++ b/drivers/pci/msi/msi.c @@ -424,8 +424,10 @@ int __pci_enable_msi_range(struct pci_dev *dev, int minvec, int maxvec, int rc;

#ifdef CONFIG_LOONGARCH - if (maxvec > 32) + if (maxvec > 32) { maxvec = pci_irq_numbers; + minvec = min_t(int, pci_irq_numbers, minvec); + } #endif

if (!pci_msi_supported(dev, minvec) || dev->current_state != PCI_D0) @@ -810,8 +812,10 @@ int __pci_enable_msix_range(struct pci_dev *dev, struct msix_entry *entries, int int hwsize, rc, nvec = maxvec;

#ifdef CONFIG_LOONGARCH - if (maxvec > 32) + if (maxvec > 32) { nvec = pci_irq_numbers; + minvec = min_t(int, pci_irq_numbers, minvec); + } #endif

if (maxvec < minvec)