-----Original Message----- From: Huisong Li lihuisong@huawei.com Sent: Tuesday, April 20, 2021 17:01 To: dev@dpdk.org Cc: Yigit, Ferruh ferruh.yigit@intel.com; Li, Xiaoyun xiaoyun.li@intel.com; linuxarm@openeuler.org; lihuisong@huawei.com Subject: [PATCH V3 6/7] app/testpmd: add forwarding config in start port
Most operations in testpmd that need to update the forwarding streams in testpmd call fwd_config_setup(). In some scenarios, eg, dev_configure is called again, the forwarding streams may not be updated. As a result, the actual forwarding streams cannot be queried by "show config fwd" cmd.
I don't agree on this. Fwd config should be only changed after the user change something like nb-cores, queue number, eth-peer in non-dcb mode. These are already done in those commands.
You should do fwd_config_setup at the end of cmd_config_dcb_parsed(), I agree on this. But doing it in start port seems to do redundant times of fwd_setup. It's not really needed.
The procedure is as follows: set nbcore 4 port stop all port config 0 dcb vt off 4 pfc on port start all show config fwd
Signed-off-by: Huisong Li lihuisong@huawei.com Signed-off-by: Lijun Ou oulijun@huawei.com
app/test-pmd/testpmd.c | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c index abcbdaa..f8052b6 100644 --- a/app/test-pmd/testpmd.c +++ b/app/test-pmd/testpmd.c @@ -2678,6 +2678,12 @@ start_port(portid_t pid) } } }
/*
* In some scenarios, eg, dev_configure is called again, the forwarding* streams may not be updated. As a result, the actual forwarding* streams cannot be queried by "show config fwd" command.*/fwd_config_setup();
printf("Done\n"); return 0;
-- 2.7.4